If the compressor works and the car does not rise in the back, replace the air bags. If both are good, replace the compressor. If there is power, check for a good ground. Access the air compressor in the front, under the hood, and check the electrical connector for power. If there is power, turn the air suspension switch to "off" and lower the car. Use the circuit tester to check for power at the leveling switch. Turn the air suspension switch to the "on" position. Put a floor jack under the axle and raise the axle to the point where it is just beginning to lift the car off the jack stand. If there was continuity, connect the arm and the electrical connector.Ĥ.
As the arm is raised, there should be continuity. There should be no continuity with the arm down. Test the switch with the ohmmeter by checking across both terminals while slowly moving the arm. If there is power, turn the air suspension switch to 'off' and lower the car. Loosen the arm of the switch from the axle. Turn the air suspension switch to the 'on' position. Pull the electrical connector off the switch. Inspect the leveling switch on the axle, making sure it is not bent and is connected. If there is power, turn the switch to the off position, raise the vehicle and place it on jack stands in the rear. If one terminal has power and the other does not, replace the switch. If it does not come on, test the switch terminals for power, using a circuit tester. Listen for the compressor to come on while pushing down on the rear bumper.
Turn the ignition key with the engine off. Always turn off the switch before lifting the car, because the sensor will think the car is rising and keep the air bag valves open, ruining the rear air suspension.ģ. This switch is used when the car is in for service. If the fuse is all right, check the air suspension switch in the trunk and make sure it is on. If the back of the car is low, indicating that the air suspension is not working, and the air suspension light is on, check the fuse first. When the load is removed and the arm moves down, indicating that the back of the car has risen, the sensor opens the valve on the air bags and allows air to escape, lowering the car.Ģ. When the arm is pushed up, it turns on the air compressor and fills the air bags to level the car.
When the rear of the car drops due to increased load, the arm is pushed up. These valves are operated via a leveling sensor that is attached to the body of the car and to the rear axle by a movable arm. This is a relief valve that allows air to be exhausted when activated, and which senses the amount of air pressure within the air bag to keep both sides equal. On the top of each air bag is a electrical valve. The Lincoln Town Car's air suspension uses a small, separate air compressor under the driver's side left fender well, with air lines running to the air bags. Find out more about our advertising opportunities.Aug. where is the air suspension pump located on a 1997 lincoln town car - Lincoln 1998 Town Car question. Advertise Advertising on is well-targeted, has unique benefits, and is highly successful. Looking for something lighter? Read our funny complaints to see people who found humor in a bad situation. Vehicle Problems Find out what cars to avoid, view the latest problem trends, or keep up-to-date with the most recently reported problems. Contact us with any comments or concerns.
#Deskconnect airline from air pump on lincoln town car drivers
0 kommentar(er)
